Maxtor Diamondmax 16 4r080j0 4a80j0ramb1tu0 80g Repair Service

Would you like to estimate data recovery cost?

Maxtor DiamondMax 16 80 GB
Part Number/Code 4A80J0RAMB1TU0
Model: 4R080J0
Factory internal code: Falcon

Not your Maxtor drive?
See all Maxtor hard disks

Our data recovery cost starts
as low as $70

Get you quote now!

... or Would you like FLAT RATE?

If you have a dead, not spinning, or clicking hard drive with any obvious symptoms of the physical damage, you might just want to go ahead with a flat rate pricing.

One FLAT RATE / FIRM PRICE covers any recovery procedures needed to be taken, including clean room drive repair manipulations.

* Regular service is for 5-7 days turnaround

** Order an Emergency service when time is critical factor. The time frame for EMERGENCY SERVICE: same day if possible, or normally 1 to 2 days. Some jobs take longer time depending on the complexity.

How to recover DiamondMax Plus 8 (6E040L0510653)

Drive is NOT visible in BIOS. Possibly caused by installation of MS X Box 360 Media...A program that allows 360 to read files from PC. Probably just being paranoid. System worked fine after this install for a day. It then froze and had to be forced to shut down (held power button). Upon reboot, this drive (master) and the slave western digital drive on same ribbon were not recognized by bios. I disconnected slave drive, hoping that this was somehow the problem. The best that I could get from the bios was the drive being recognized as 'N40P'. I did quite a bit of poking around on the web (after putting another DM 8 drive in from another PC) to discover that the firmware microcode is probably corrupt. The only software that I could find (that didn't require special hardware) seemed a bit sketchy and had a retail similar to the cost of your services. So I didn't try to do anything with the firmware. While it's hard to swallow, I think that a budget of $600 is reasonable only because of those pictures of my children, which I couldn't bear having to tell my wife are gone.

Jeremy A.
Hamilton, OH USA

Dear Data Recovery team,
God Bless You for what you do, saving lives. I cannot thank you enough for what you did, practically saved my life.
Thank You,
Jeremy A.

Inaccessible Seagate Barracuda 7200.10 ST3300820A drive

Failure: Cannot reboot PC - receive the following error: Primary hard disk drive 0 failure. Strike the F1 key to continue, F2 to run the setup utility.
I can see the drive electrically in the BIOS or SETUP as a D Drive or the secondary drive; however in Windows it can NOT see the drive as D. Also when I put her drive in my TESTBED as D DRIVE and boot from WINDOWS XP on the C DRIVE and go into My Computer, Manage, and Disk Management it doesn't display the second drive only the C Drive as DISK 0.

NCR WATERLOO
Waterloo, Ontario Canada

Outstanding results, as usual. Thanks a lot for recovering the data off again.
Best regards,
Jeff M.

Maxtor DiamondMax 16 4R080J0 4A80J0RAMB1TU0 80G Hard Drive

Would you like to estimate data recovery cost?

... or Would you like FLAT RATE?