$70 Data Recovery: Deskstar P7k500 Sata Hdp725032gla380 320g

Hitachi Deskstar P7K500 SATA HDP725032GLA380 320G Hard Drive

DataBE offers professional, honorable data recovery service at $690 flat. We can rescue the lost data from crashed HDP725032GLA380 320 Gb Hitachi hard drive. The great new addition to our website is the tracking case device that allows getting the current status at any time during the ongoing recovery process.

Would you like to estimate data recovery cost?

Hitachi Deskstar P7K500 SATA 320 GB
Model: HDP725032GLA380

Not your Hitachi drive?
See all Hitachi hard disks

Our data recovery cost starts
as low as $70

Get you quote now!

... or Would you like FLAT RATE?

If you have a dead, not spinning, or clicking hard drive with any obvious symptoms of the physical damage, you might just want to go ahead with a flat rate pricing.

One FLAT RATE / FIRM PRICE covers any recovery procedures needed to be taken, including clean room drive repair manipulations.

* Regular service is for 5-7 days turnaround

** Order an Emergency service when time is critical factor. The time frame for EMERGENCY SERVICE: same day if possible, or normally 1 to 2 days. Some jobs take longer time depending on the complexity.

How to recover IC35L120AVVA07

I had to reboot the system after not using for awhile. When the PC rebooted, the HDD that I am sending you was not recognized. I checked in the BIOS setup and the IDE channel is still active, but it reports no drive is attached. The only thing I've done is checking the drive in BIOS and powered up the drive without the IDE connection. The drive spun up and didn't make any unusual noises. I stopped at that point from trying to do anything after I read your web site warning about trying to change the electronics.

Tom H.
Rockwall, TX USA

Dear Databe,
It looks like you are able to access all my files and save the data. Thank you for your quick, professional approach to my problem.
Thank you,
Tom H.

How to recover DiamondMax Plus 8 (6E040L0510653)

Drive is NOT visible in BIOS. Possibly caused by installation of MS X Box 360 Media...A program that allows 360 to read files from PC. Probably just being paranoid. System worked fine after this install for a day. It then froze and had to be forced to shut down (held power button). Upon reboot, this drive (master) and the slave western digital drive on same ribbon were not recognized by bios. I disconnected slave drive, hoping that this was somehow the problem. The best that I could get from the bios was the drive being recognized as 'N40P'. I did quite a bit of poking around on the web (after putting another DM 8 drive in from another PC) to discover that the firmware microcode is probably corrupt. The only software that I could find (that didn't require special hardware) seemed a bit sketchy and had a retail similar to the cost of your services. So I didn't try to do anything with the firmware. While it's hard to swallow, I think that a budget of $600 is reasonable only because of those pictures of my children, which I couldn't bear having to tell my wife are gone.

Jeremy A.
Hamilton, OH USA

Dear Data Recovery team,
God Bless You for what you do, saving lives. I cannot thank you enough for what you did, practically saved my life.
Thank You,
Jeremy A.